11
42768-01 • 02/23/09 • Hunter Fan Company
Attaching the Upper Switch Housing
7-5. Remove the four upper switch housing screws holding the steel shipping
bumper onto the bottom of the fan. Save the screws and discard the
shipping bumper.
7-6. Feed the upper plug connector through the center hole in the upper
switch housing.
7-7. Align the holes in the upper switch housing with the spokes in the
mounting plate.
7-8. Insert and tighten the four upper switch housing screws into the outermost
holes in the upper switch housing.
CAUTION:
Make sure the upper switch housing is securely attached
to the switch housing mounting plate. Failure to properly attach and
tighten all four housing assembly screws could result in water entry
into live connection area and/or the switch housing and light fixture
falling.
Attaching the Lower Switch Housing/Light Kit Assembly
7-9. Locate the lower switch housing screws.
NOTE:
Depending upon your fan model, these screws may be installed
in the four spokes from the switch housing mounting plate, or they may
be located in the sack parts.
7-10. Partially install the lower switch housing screws into the spokes from the
switch housing mounting plate.
NOTE:
If these screws came installed, make sure that they are partially
installed in order to complete the following steps.
7-11. Connect the upper plug connector to the lower plug connector from the
lower switch housing assembly.
NOTE:
Both plug connectors are polarized and will only fit together
one way. Make sure that both connectors are properly aligned before
connecting them together. Incorrect connection could cause improper
operation and damage to the product.
7-12. Align the keyhole slots in the lower switch housing with the upper switch
housing screws that were installed in Step 7-7.
7-13. Turn the lower switch housing clockwise until the corners of the lower
switch housing align with the corners of the motor housing. If the corners
do not align on the first attempt, turn the lower switch housing to line
one keyhole slot up with the next screw to either side and try again.
7-14. Tighten all lower switch housing assembly screws.
7 • Completing Your Installation With a Light Fixture (Continued)
Step 7-5
Step 7-7
Upper
Switch
Housing
Screws
Spokes
Motor
Housing
Lower
Switch
Housing
Screw
Keyhole
Slots
Lower
Switch
Housing
Corners
Lower Switch
Housing Screws
