Hunter 42737-01, Инструкция по установке и эксплуатации

Страница: 6 / 7

10
Hunter Fan Company 42737-01 • 11/14/06
11
42737-01 • 11/14/06 Hunter Fan Company
7 • Completing Your Installation With or Without a Light Fixture
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
Your Hunter fan comes with an integrated light fi xture assembly and an
optional switch housing cap and plug button. Th
is feature gives you the
option of installing the fan with OR without the included light fi xture.
Th
e steps below direct you whether or not you are installing a light
fi xture.
WARNING: Use only the light fi xture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are fi rmly situated in the narrow end of the keyhole slots.
Install the remaining #6-32 x 3/8” screw into the housing. Tighten
all three screws fi rmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fi xture falling.
Step 7-4
7-6. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fi t together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-7. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing
7-8. To install each shade, fi rst loosen the three thumbscrews.
7-9. Raise the shade to the light fi xture. Tighten the thumbscrews
securely.
7-10. Install four B10 candelabra light bulbs (60 Watt maximum each).
Note: Glass shade style may vary.
Lower Switch
Housing
Plug
Connector
Housing
Assembly Screw
Plug
Connector
Detail
Steps 7-5 – 7-6
Steps 7-7 – 7-9
Th umbscrews
Shade
Bulb