9
42700-01 • 01/15/08 • Hunter Fan Company
6 • Setting the Remote Transmitter and Receiver
CAUTION:
The remote control device complies with part 15 of the FCC rules.
Changes or modifications not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
WARNING:
Use only the Hunter Fan speed control supplied with this fan.
IMPORTANT!
Before you change the jumper settings, make sure the
battery is not connected to the transmitter.
6-1. Change the position of the jumpers in the remote transmitter
and the receiver. Make sure that the jumpers match in the remote
receiver and transmitter. If they don’t match, the transmitter will
not function.
6-2. Install the included 12-volt battery into the transmitter.
Setting Transmitter and Receiver Codes
When two or more fans are located near each other, you may desire
to have the receiver/transmitter for each fan set to a different code,
so that the operation of one fan does not affect the operation of the
other fans.
The jumpers for the receiver are located on the flat surface of
the receiver. The jumpers for the transmitter are in the battery
compartment. The jumpers are very small; you can move them most
easily using a small pair of pliers or tweezers.
4 3 2 1
4 3 2 1
4 3 2 1
4 3 2 1
4 = off
3 = on
2 = on
1 = on
4 = off
3 = on
2 = off
1 = on
Receiver Jumpers
4 3 2 1
4 3 2 1
4 3 2 1
4 3 2 1
4 = off
3 = on
2 = on
1 = on
4 = off
3 = on
2 = off
1 = on
Example Jumpers Settings
Receiver 1
Receiver 2
Transmitter 2
Transmitter 1
4 3 2 1
4 3 2 1
4 3 2 1
4 3 2 1
4 = off
3 = on
2 = on
1 = on
4 = off
3 = on
2 = off
1 = on
