Re-install the board, install the batteries, then in-
stall the back cover. Make sure the data port plug
is in place while assembling the case halves.
Check the remote for proper operation.
Battery Replacement
WARNING
The port on the bottom is not a charging port, it is a data connection for future devices. Do
not connect any charging adaptors to this port.
To replace the batteries, remove the two screws securing the battery cover then gently pry off the cover.
Replace the batteries with two new “AA” size batteries, making sure to observe the correct polarity.
Replace the the battery cover and reinstall the two cover screws.
Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1)
Page 5 of
7
