3
4
5
Assembly Steps
Ø10 locknut
Ø10 locknut
Ø12 washer
Ø12 washer
Ø12 washer
Ø10 washer
Ø10 washer
Split pin
Split pin
Front axle plate
Steering shaft
Steering shaft
Driving wheel
Wheel
Rear axle
●
Fit the driving wheel onto the rear axle.
Make it match with the gear box.
●
Fit a Ø12 washer onto the rear axle.
●
Fit a Ø10 locknut to the end of the rear
axle.
●
Repeat this procedure to assemble the
other driving wheel to real axle.
●
Tighten the locknuts on both sides of
rear axle with two spanners. DO NOT
over-tighten.
●
Remove a Ø10 locknut and a Ø12
washer from the front axle. And leave
over a Ø12 washer.
●
Fit a wheel onto the front axle.
●
Fit a Ø12 washer onto the front axle.
●
Fit a Ø12 locknut to the end of the front
axle. And tighten with a spanner, DO
NOT over-tighten.
●
Repeat this procedure to assemble the
other wheel to front axle.
●
Turn the vehicle body on its side.
●
Insert the straight end of the steering
shaft up through the hole in the vehicle
body.
●
Insert the bent end of the steering shaft
through the hole in the front axle plate. Fit
a Ø10 washer onto the steering shaft, and
insert a split pin through the hole in the
steering shaft. Bend the ends of the split
pin back using a pair of pliers.
-6-
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE. PLEASE
CONTACT HUNTER PRODCUTS CUSTOMER SERVICE TOLL FREE NUMBER: 1800 224 094
OR VISIT WWW.ELECTRICRIDEON.COM.AU
