Hunter Marine 2006 H46, Руководство пользователя

Страница: 201 / 209

120V.A.C.
(230V. OVERSEAS MODELS)
SYSTEM TROUBLESHOOTING GUIDE
COMPONENT SYMPTOM POSSIBLE SOLUTION/S
SHORE POWER "A" NO POWER TO PANEL SEE "POWER SYSTEM OPERATIONS" PAGE 63A-2
CHECK DOCKSIDE BREAKER AND/OR BREAKER #1
LOCATED IN AFT CABIN OR COCKPIT LOCKER.
CHECK "RESETS" ON (OPT.)INVERTER (SEE "INVERTER MAN.")
OUTLETS #1 & 2 NO POWER SEE "POWER SYSTEM OPERATIONS" PAGE 63A-2
IS OUTLET BREAKER/S ON?
CHECK RESET ON G.F.I. OUTLETS AT
GALLEY & AT NAV. STATION.
CHECK RESETS ON (OPT.) INVERTER (SEE "INVERTER MAN.")
MICROWAVE NO POWER IS BREAKER ON?
SEE "POWER SYSTEM OPERATIONS" PAGE 63A-2
IS MICROWAVE ON?
SEE "MICRO MANUAL"
WATER HEATER NO POWER IS BREAKER ON?
SEE "POWER SYSTEM OPERATIONS" PAGE 63A-2
WON'T HEAT WATER CHECK "RESET" ON HEATER SEE "WATER
HEATER MANUAL" FOR LOCATION.
WATER TOO COLD/HOT SEE "WATER HEATER MANUAL" FOR
THERMOSTAT ADJUSTMENT AND/OR
ELEMENT REPLACEMENT,
SEEK QUALIFIED PERSONELL.
BATTERY CHARGER NOT CHARGING BATTERY/S IS SHORE POWER "A" ON
(STANDARD) IS BATT. CHARGER BREAKER ON?
IS RESET TRIPPED ON HOUSE BATTERY ON/OFF PANEL
CHECK FUSES BEHIND HOUSE BATT. ON/OFF PANELS
ARE BATTERY CONNECTIONS GOOD?
INVERTER /BATT. CHARGER INV. NOT SUPPLYING A.C.POWER IS INVERTER REMOTE SWITCH AT NAV STATION ON?
(OPTIONAL) IS DESIRED APPLIANCE BREAKER ON?
(IN INVERTER MODE) INV. ON BUT UNABLE TO OPERATE IS BATTERY VOLTAGE LOW? SEE VOLTAGE
DESIRED APPLIANCE/S
DISPLAY ON INVERTER REMOTE PANEL,
ARE YOU ASKING THE INVERTER TO POWER
MORE THAN IT IS CAPABLE? SEE "INVERTER
MANUAL" FOR INFORMATION REGARDING
POWER OUTPUT CAPABILITIES.
CHECK "RESETS ON (OPT.) INVERTER (SEE "INVERTER MAN.")
INVERTER/ BATT. CHARGER NOT CHARGING BATTERY/S IS SHORE POWER "A".ON?
(OPTIONAL) SEE "POWER SYSTEM OPERATIONS" PAGE 63A-2
(IN CHARGING MODE) IS BATTERY SELECTOR SWITCH IN "ON" POSITION?
CHECK IN-LINE 300amp FUSE AT BATTERY
ARE BATTERY CONNECTIONS GOOD?
INVERTER REMOTE SWITCH SHOULD BE IN
THE "OFF" POSITION. (THIS IS NECESSARY IN THE
EVENT YOU "LOSE" SHORE POWER, THE INVERTER
DOESN'T GO INTO INVERT MODE CAUSING BATT./S
TO DRAIN IF YOU LEFT AN A.C. APPLIANCE ON..
PAGE 65B-1