6
Installation
INSTALLATION
Inside or Outside Mount — Mount the Installation Brackets
Measure and mark 2½" in from each jamb for bracket location.
If more than two installation brackets came with your order, space additional bracket(s) on
studs, evenly between the two end brackets and mark their location.
Mark the location of the screw holes by the brackets
on the previously made marks.
IMPORTANT:
The brackets must be level and aligned to each other.
Use a
3
/
32
" drill bit to drill holes for the screws.
IMPORTANT:
If you are fastening the installation brackets to drywall, be sure to use wall
anchors and follow the instructions provided with the anchors. (Anchors not provided.)
Use a level to check that the mounting surface is level. Shim the brackets if necessary.
(Shims not provided.)
Peel back the protective covering from the top and endcaps of the headrail. Leave the rest
of the protective covering on the front of the headrail.
Install brackets by sliding the headrail into the groove inside the front lip of the bracket and
then push towards back of the brackets until snaps into place.
Completely remove the protective covering from the headrail.
