DecoFlex Wirefree™ Wall Switch
P-0035HD
INSTALLATION
© Copyright 9/2019 SOMFY SYSTEMS, INC.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Included is a special SOMFY low voltage device mounting bracket which attaches to drywall and eliminates the need for an electrical box.
The bracket can be used in two mounting type configurations:
Individual or “stand-alone” (1 switch) mounting configurations (shown below),
Or adjacent (pre-existing) Decora-style light switch (specific instructions available). This unique mounting bracket allows the necessary spacing for 2 adjacent switches
and a new “Double Gang” (2 Gang) wall plate to be installed (see photo 8) resulting in an aesthetically pleasing professional installation
NOTE:
When following configuration 1, the mounting bracket is not designed to be used inconjunction with “old-work” or retrofit electrical boxes. (Please check local codes to determine if an
electrical box is required for your installation.) For increased radio performance, Somfy recommends the use of non-metallic electrical enclosures.
1
2
Tools required for installation:
Screw drivers (phillips and bladed), dry-wall saw, wall stud sensor, non-marring tape and pencil
1
2
Pick a location for the switch
and using a stud sensor,
locate a space between studs
and mark (for reference) with
removable tape or pencil.
3
Place the flat side of mounting
bracket (included) against
the wall, then trace the inside
shape of the bracket on wall
using a pencil or thin marker.
Using a dry-wall saw (or similar)
begin to cut the drywall along the
traced outline. Do not cut hole larger
than outline as this may result in a
loose fitting bracket.
NOTE: Recommended hole dimensions
are (1 5/8” W x 3 7/16” L)
4
5
Insert bracket (as shown) into hole
and carefully bend bracket tabs 90
degrees behind the dry-wall to
ensure a tight secure fit.
6
Position the DecoFlex switch into
mounting bracket aligning the
screw holes. Secure switch to
mounting bracket with screws
(provided).
Attach a Decora-style wall
plate over the switch to
complete installation.
OPERATION
1
Select the CONTROL BUTTON(s) programmed to a specific window covering(s). The adjacent LEDs will illuminate to
indicate the CONTROL BUTTON selected.
To raise the window covering(s), press the
UP
button. To lower the window covering(s), press the
DOWN
button.
To stop the window covering(s) at any time, simply press the
STOP
button.
For wall switches programmed to use group function, select a control button followed by an action
(default: Up, Stop and Down).
For detailed product operation information, refer to the product programming instructions.
2
3
4
LED
Indicators
Down
Button
Control
Buttons
Stop Button
Up Button
NOTE: Switches require programming in order to operate as intended.
RTS Programming
Button
