Humly Room Display, Руководство пользователя

Страница: 7 / 32

Humly Room Display - User Manual Prepared By: Haian & Robin
Revision - B Approved By:
Mounting instructions
Standard walls
IMPORTANT! Read the safety instructions carefully before using the mounting instructions.
1. Unmount the back plate of the device, by carefully turning it counter clockwise. Use a spirit level
to adjust it horizontally. Height from floor to center of device approximately 1500 mm / 5 ft.
2. Use the holes in the back plate to mark out hole positions on the wall.
3. Decide on the direction you want to exit the cables and make sure the hole for the cable exit is
facing this direction.
Note! If you plan to route cables into the wall using the big open area in the middle of the back plate we
recommend facing the cable hole either up or down, not sideways.
4. Make sure that the markings are exactly leveled and drill the holes for the mounting bracket.
Mount the back plate to the wall with the screws and route the cables through the appropriate
cable channels on the device.
Note! Use 2 ¡ 4 scr ews depending on the structural capacity of the wall. Always drill holes an d use
suitable plugs for wall types such as concrete, plaster etc. Choose a screw type that is suitable for the type
of plug and wall concerned. Use scr ews with a diameter of 4 ¡ 5 mm / gauge # 7 - 10 and minimum
length of 35 mm / 1- 3 /8¡. If uncertain always contact a specialist or dealer for assistance with wall
mounting.
Note! Do not remove the protective film on the back of the mounting bracket. The ¡sticky surface¡ should
only be used for glass wall mounting.
5. Moun t the device on the bracket by fitting the talons on the back plate with the h oles in the
device and gently turn it clockwise to snap it in place. Secure it with the safety screw.
Glass walls
IMPORTANT! Read the safety instructions carefully before using the mounting instructions. For
mounting on smooth glass surfaces only! Make sure the surfaces are clean, dry and above 15¢C / 59¢F
before mounting! Avoid mounting in direct sunlight!
7