QUICK ST
AR
T GUIDE
4
Installing Humboldt HCM-5080 Controller
To install the Humboldt Controller, locate the controller
mounting bracket, and using the bracket as a guide, mark
the position for two mounting holes on the upper section of
the compression machine. To ensure that the mounting plate
and the pump are level, use a bubble level to make sure the
mount is level.
1. Drill and tap two (2) 1/4 -20 UNC holes using the place-
ment determined above.
2. Using the supplied bolts and the bracket, bolt the bracket
to the compression machine. See photo #4 below.
3. Mount the HCM-5080 Controller to the bracket you just
attached to the compression machine. See photo #5
below. There are four (4) bolts supplied for this step.
Photo #3— Pump mounted to
support bracket
Your machine with the mounted pump assembly should look
like the photo below.
