Humanscale Quickstand, Руководство по установке

Страница: 4 / 12

4
S T EP 4
Measure Work Surface Depth
IMPORTANT: Please check the depth of your work surface
- If you are installing a QuickStand with a Large Platform, your QuickStand
is pre-set to attach to a 29” (750 mm) deep work surface
- If you are installing a QuickStand with a Small Platform, your QuickStand
is pre-set to attach to a 23” (600 mm) deep work surface
Tools: Measuring Tape
• The distance between the front edge of the Platform to
the inside face of the Base Clamp must be equal to the
work surface depth (fig. D)
• If the Base Clamp is in the correct position, please proceed to step 6
• If the Base Clamp needs to be adjusted, please proceed to step 5
S T EP 5
Adjust Base Clamp for Correct Work Surface Depth
Tools: Measuring Tape
5 mm Hex Key
• Loosen or remove the (4) M8 x 10 mm Pan Head Machine
Screws and slide/reposition the Base Clamp to achieve the
correct work surface depth (fig. E)
NOTE: If you will be installing the Grommet Mount/Bolt-through
base instead of the clamp, please refer to the Grommet Mount/Bolt-
through kit instructions now.
D
E
S T EP 3
Attach Platform
Tools: 6 mm Hex Key
• Ensure the Platform is equally spaced from
the Base Plate on either side (fig. C)
• Using the (2) M8 x 10 mm Cap Head Machine
Screws and the Washers from step 1, secure
the Platform to the QuickStand unit
Base Plate
Platf
orm
C