Hughes HX200, Руководство по установке

Страница: 82 / 160

Chapter 5 • The System Control Center
72
1038054-0001 Revision B
7 The transmitter is not available because the
satellite receiver is not tuned for normal
operation Occurs when the transmitter is disabled for safety
reasons. If this condition occurs during installation or
commissioning, close the Antenna Pointing program
and resolve the problem.
8 The transmitter is available This is the normal operational state and indicates
that the transmitter is ready to transmit data.
9 The transmitter is adjusting for optimal network
timing Typically occurs when the satellite router is first
commissioned or the first time it is used for data
traffic. This condition will normally occur before the
satellite router can transmit successfully. Typically,
this process usually takes less than a minute.
10 The transmitter is unable to communicate with
the gateway Indicates that the satellite router has stopped
transmitting user data due to a number of failures
when sending data to the system gateway over the
satellite link. This condition could be the result of
packet loss due to inclement weather conditions or,
rarely, return channel equipment failures in the
system gateway.
11 The transmitter is not available because the
receiver software is out of date Indicates that the software version currently running
is out of date and no longer viable. From time to
time, software updates are required to
accommodate network infrastructure and feature
upgrades as well as to maintain network efficiency
and fix known problems. To ensure uninterrupted
operation, these updates occur automatically.
However, it is possible to miss an update if the
satellite router is shut down for an extended period
of time. Instruct the user to contact their service
provider to obtain the software update.
12 The transmitter is not receiving network control
messages from the gateway Indicates an equipment outage at the HX system
gateway. This should be a transient condition and
the system should recover automatically. If it does
not, contact Technical Support.
Table 8: Transmit code (TxCode) messages and corrective actions (Continued)
Code Message Corrective actions