STEP 3. Remove modulator and modulator valve. Grind valve as shown in figure 3.
Install modified valve and modulator into case.
STEP 4. If the transmission is out of the vehicle, install check balls into transmission as
shown in figure 1. If the transmission is in the vehicle, install check balls onto the
separator plate (Figure 2) using as little assembly lube as possible to hold check balls in
place.
STEP 5. Install case gasket and separator plate onto transmission, using the detent
solenoid to hold it in place. Hand tighten two bolts on solenoid. Do, not completely
tighten until valve body is installed.
STEP 6. Install new valve body gasket and valve body. Make sure when installing valve
body that you engage the manual valve into the shift linkage.
STEP 7. Tighten all valve body bolts and detent solenoid.
STEP 8. Install filter and pan. Shift pattern: P, R, N, 3, 2, 1
