7
4) Measure from top left edge of window 12" (See Figure B). Peel adhesive cover off the back
of the 1" Velcro's adhesive pad. Place the pad to the right of the 12" mark and press firmly. The
pad will be on the opposite side of the handle.
Installing window tracks:
Take one track and align the pre-drilled holes on the track with the pre-drilled holes on the
blind around the opening for the window. Insert the screw into the hole and attach the nut. Do
not tighten. Repeat this step on the other 7 window tracks. Next take a window and slide it into
the tracks. It should rest on the 2x4 piece of wood that runs below the window. Once you have
the window in the tracks, you can tighten all the screws. If it doesn't slide smoothly, you may
have to re-drill the holes for a better fit using a 3/16" drill bit.
Installing Velcro Window Pads
:
Take the window and slide it up into the open position. Locate where the velcros pad that you
put on the top of the window hits on the blind wall and that is where you will put the velcros
pad on the blind wall. Press the pad firmly against the wall of the blind. This will hold your
window in the open position.
