2
INSTRUCTIONS:
1) With wall panels A & B vertical, one person stands on the inside with nuts & the other on the
outside with the screws (8-32 x 3/4) (See Fig.1). Overlap the offset corner of Panel A with Panel
B. Using the predrilled holes, starting at the top insert screws (8-32 x 3/4) one at a time down the
edge of Panel B.
DO NOT PUT A SCREW IN THE 3RD HOLE UP FROM THE
BOTTOM. A WOOD SCREW, #10 X 1", WILL GO THERE AT A LATER TIME
DURING ASSEMBLY. DO NOT PUT A SCREW IN THE BOTTOM HOLE OF EACH
PANEL UNTIL FLOORING IS PLACED AT END OF ASSEMBLY.
Make sure panels are
tight against each other before you insert each screw.
2) Repeat above steps on panels A & C. Now attach panel D (door panel)to panels B & C.
3) Place roof over the top of the panels. With one person inside and one out, insert screws (8-32
x 3/4) from the outside into predrilled holes along the bottom edge of roof panel. Again make
sure roof panel is tight against the wall panel before you insert each screw.
Note: Some screw
holes may not line up. In the event this happens, re-drill holes from the outside of the roof
to line up with holes in the panels.
***
The next steps are for the optional use of 2 x 4's for extra support. If you
choose not to do this feature skip to step 8 to complete assembly of your box
blind.
4) On the inside of the box blind, insert 2 x 4 #1 into the horizontal grove in the side Panel D,
just above the door and below the window (see Fig. II). Make sure the 2 x 4 #1 is pushed tight
against the right side lip of Panel D. Now from the outside, insert screws#10 x 1 into the 2 x 4
through predrilled holes of Panel D. On the CORNER, make sure Panels D & B are tight against
each other before you secure the screw.
5) Install 2 x 4 #2 into Panel B just as instructed above. Make sure 2 x 4 #2 is pushed tight
against the side of 2 x 4 #1. Insert screws #10 x 1 from outside.
6) Install 2 x 4 #3 into Panel C just as instructed above. Make sure 2 x 4 #3 is pushed tight
against the side of 2 x 4 #1. Insert screws #10 x 1 from outside.
7) Install 2 x 4 #4 into Panel A just as instructed above. Make sure 2 x 4 #4 is tight against the
sides of 2 x 4 #2 and #3. Insert screws #10 x 1 from outside. Now from the inside of the box
