Hughes Network AN8-074P, Руководство по установке

Страница: 28 / 62

Chapter 2 • Antenna parts and required tools
14
1037749-0001 Revision B
Tools
Table 2 lists the tools required to assemble and install the
antenna.
Table 2: Tools required to assemble and install the antenna
Tool Details
Socket wrench, ½-inch
(with 3-inch extension)
For 5/16-inch bolts.
Open-end wrench,
½-inch For 5/16-inch bolts. Two of the Az/El
canister nuts are not accessible by socket
wrench. Some nuts and bolts require a
second wrench to prevent turning.
2 open-end or socket
wrenches, 7/16-inch For 1/4-inch bolts. Some nuts and bolts
require a second wrench to prevent turning.
Torque wrench With ½-inch and 7/16-inch sockets capable
of torquing to 8 ft-lb.
Long-shaft hexagonal
ball driver (7/64-inch) For #6-32 Allen screws. Driver shaft should
be at least 5 inches long.
Phillips-head
screwdriver, 1/4-inch For screw used to help secure antenna
reflector to reflector bracket.
Bubble level Used to make sure that the mast is plumb.
Compass Used in determining antenna azimuth.
Pencil Carpenter’s pencil.
Weather grade silicon
sealant Used to keep moisture away from cable
connections.
Weatherproofing tape Used to keep moisture away from cable
connections
Approved RG6 cable Used for IFL between IDU and antenna.
UV-rated cable ties Used to secure slack in cables to antenna
mast.