Hughes Network Systems GMH2000, Руководство по установке и обслуживанию

Страница: 41 / 105

8018653 1.1 Installing BSC hardware • 2-19
8. While two installer stabilize the side of the rack on the pallet
truck, the other two installers should rotate the pallet side of the
rack onto the pallet truck.
9. Use the floorplan supplied in the Site Planning Guide
(customer's documentation package) to determine where the
equipment racks are to be situated. Lay out the rack locations
using the chalk line and tape measure.
10. If you will be installing a ground isolation pad and earthquake
bracing kit, go to step 11. Otherwise, go to step 12.
11. Procedure is currently TBD.
12. Position the initial rack in its proper place using the pallet truck.
13. If the rack is being installed on a level raised floor, go to
step 14. Otherwise, there are leveling feet in the base of the
rack, one near each corner (see figure 2-8) that are used to
plumb the rack. Verify that the rack is correctly positioned,
then, using a 1/2-inch (11-mm) socket, extend each foot until a
level placed across the top of the rack—in two different axes—
shows that the rack is plumb (see figure 2-9).
14. If there are no expansion BSC racks to install, continue on to
section 2.5, “Installing BSC input power and ground cables.”
Otherwise, repeat steps 1 through 13 to install the expansion
racks, then go to section “Anchoring multiple BSC racks.”
Note
Leave approximately 1/4 inch (5 mm) of space
between each rack when you install it (see
figure 2-10).