Hudson Terraplane Special 1935, Руководство пользователя

Страница: 46 / 49

44 TERRAPLANE SPECIAL SIX
and is in harmony with interior appointments or exterior finish. In many cases
mountings are provided and no drilling or cutting is required to install the
equipment; however, any of these items can be readily installed by an Authorized
Terraplane and Hudson Dealer.
High Compression Cylinder Head
The composite type cylinder head giving 7 to 1 compression ratio is available
for use on the 1935 Terraplane engine. Although this requires the use of high
octane fuel, it increases the engine output to 100 horsepower and under compar-
ative driving increases gasoline mileage, partially offsetting the extra fuel cost.
Acceleration and hill climbing are greatly increased by the added power obtained.
Axleflex
This unit is interchangeable with the standard front axle and gives independent
front wheel springing while retaining the heavy drop forged construction of
conventional designs.
Stabilizer
The use of a stabilizer reduces body sway. The stabilizer is used on all cars
equipped with Axleflex and can be fitted to cars with the standard front axle.
Fender Lamps
All models have a small parking bulb in the headlamp. Fender lamps can be
installed on any model and connected in place of the headlamp parking bulb.
These fender lamps are of the same design as the headlamps but are chromium
finished.
Tail and Stop Lamp—Right Hand
A tail and stop lamp especially designed for the right rear fender can be
installed on any model. This lamp is identical with the left lamp except no
provision is made for mounting a license bracket.
Electric Hand
The Electric Hand or automatic transmission control may be had on all models
as a factory installed option. This device, which is electrically controlled, permits
finger tip gear shifting by means of a small lever located immediately under the
steering wheel and utilizes the engine intake manifold vacuum to perform the
actual work of engaging and disengaging the transmission gears. The Electric
Hand also permits pre-selecting of the gears while the car is in motion, the shift
being made automatically when the clutch pedal is depressed.
Twin Horns
These horns are finished in chromium plate and are designed to blend into the
contours of the front end of the car. They are mounted on the headlamp brackets.
No drilling is required for their installation. They are available only in matched
sets, ready for attachment on all models.