Hudson Grills 305BX, Инструкция по сборке и эксплуатации

Страница: 59 / 133

25
6. Operating instructions
Safety Tips
Before opening LP cylinder valve, check the
coupling nut for tightness.
When grill is not in use, turn off all control
knobs and LP cylinder valve.
Never move grill while in operation or still hot.
Use long-handled barbecue utensils and oven
mitts to avoid burns and splatters.
Maximum load for side shelf is 10 lbs.
The grease tray must be inserted into grill and
emptied after each use. Do not remove grease
tray until grill has completely cooled.
Clean grill often, preferably after each cook-
out. If a bristle brush is used to clean any of
the grill cooking surfaces, ensure no loose
bristles remain on cooking surfaces prior to
grilling. It is not recommended to clean cook-
ing surfaces while grill is hot.
If you notice grease or other hot material drip-
ping from grill Determine the cause, correct it,
then clean and inspect valve, Keep ventilation
openings in cylinder enclosure (grill cart) free
and clear of debris.
Do not store objects or materials inside the
grill cart enclosure that would block the flow of
combustion air to the underside of either the
control panel or the firebox bowl.
The regulator may make a humming or whis-
tling noise during operation. This will not affect
safety or use of grill.
If you have a grill problem see the
"Troubleshooting Section".
If the regulator frosts, turn off grill and LP cyl-
inder valve immediately. This indicates a prob-
lem with the cylinder and it should not be used
on any product.
Putting out grease fires by closing the lid is
not possible. Grills are well ventilated for
safety reasons.
• Do not use water on a grease fire. Personal
injury may result. If a grease fire develops,
turn knobs and LP cylinder off.
• Do not leave grill unattended while preheat-
ing or burning off food residue on HI. If grill
has not been regularly cleaned, a grease
fire can occur that may damage the product.
Main Burner Ignitor Lighting
▲
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Turn ON valve from source or tank.
3. Push and turn Ignition Burner control knob
to HI and immediately press and hold
Electronic Ignition button.
4. If ignition does NOT occur in 5 seconds,
turn Ignition Burner control knob OFF, wait 5
minutes, and repeat the lighting instructions.
5. Before igniting Main Burner 1, Main Burner
2 must be lighting.
6. To ignite the side burner, follow steps 2-4
using the side burner knob.
If ignitor does not work, follow Match Lighting
instructions.
After Lighting: Turn knobs to HI position for 5
minutes to
pre-heat grill. Then turn knob to
desired setting for cooking.
Turn controls and gas source or tank OFF
when not in use.
If ignition does NOT occur in 5 seconds, turn
the burner controls OFF, wait 5 minutes and
repeat the lighting procedure. If the burner
does not ignite with the valve open, gas will
continue to flow out of the burner and could
accidently ignite with risk of injury.
Match-Lighting
▲
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging
from side of cart). Light match, place into
lighting hole on left side of firebox.
3. Push in and turn right knob to Hi position.
Be sure burner lights and stay lit.
4. Light other burners follow with steps 3.