Hud-son Oscar 330 Pro, Руководство оператора

Страница: 16 / 40

16
Installed with Adjustable Lift and Sight Gauge
Your mill has been equipped with an adjustable lift and sight gauge for ease of use. Prior
to using your mill be sure that all bolts and locks are securely in place on both the Winch
Plate (Oscar-330 only) and Sight Gauge (both Oscar-330 and Oscar-236).
To adjust the Winch position of the Oscar-330 Pro:
**MAKE SURE THE HEAD IS COMPLETELY IN THE DOWN POSITION
BEFORE ADJUSTING THE WINCH**
The Oscar-330 Pro Winch Plate located at the operators side of the mill will have 2 posi-
tions for the Winch to lock in place, one at the top of the plate and the other at the bottom.
Do not loosen bolts unless the head is completely lowered. To move the winch to a differ-
ent position, first completely lower the mill head relieving any pressure from the winch.
Once the pressure has been released loosen the winch bolts then remove the safety bolt
completely. Move the winch to the desired position then reinstall the safety bolt. Finally
retighten the winch bolts and safely test the winch.
To adjust the sight gauge on either the Oscar-330 Pro or Oscar-236:
First completely lower the mill head. Next loosen the Allen screws (2) on the sight gauge
then move the sight gauge up or down to desired location. Note that the sight gage can be
completely removed and flipped for greater height or depth if desired. Once positioned,
retighten the Allen screw and test that the sight gauge is secure. Next the scale stick will
have to be adjusted to the sight gauge. First loosen the bolts on the scale stick then move
the scale stick until the 1 inch marking is level with the center marking on the sight gauge.
Once in place retighten the scale stick and test that it is secure. Always set your sight glass
and scale stick to 1 inch off deck (when the head is completely down).
Follow all the steps to safely transport the Hud-Son Saw Mill Trailer Model
1. Lock head into travel position.
2. Raise extension legs and lock in upright positions.
3. Raise rear legs of frame and pin in raised position.
4. Raise jack to desired height, remove pin and rotate to horizontal position, hook hitch
to vehicle. Plug in lights and brakes. Hook-up safety chains and break-away switch.
(If applicable)
5. Lift front legs and lock in transport position.
6. Be sure to clean unit of all loose debris, including all bark, sawdust and dirt.
Transport Instructions