Important notes
The device must be used exclusively for its intended purpose.
The device is only approved for operation within the connected loads specified on the type label.
Do not insert any mechanical parts, especially metal parts, into the device through the ventilation
slots.
Protect the unit from moisture, humidity and condensation. Avoid using liquids near the device.
Never connect loads while the amplifier outputs are switched on.
Operate the device exclusively on the public power supply system (no generators/UPS).
To avoid personal injury and property damage, make sure that the equipment and components
used in the test are not overloaded. Read all operating instructions for the devices used thoroughly
and ensure that all defined device limits are adhered to. If there are doubts about the suitability of
the devices for the test to be performed, contact the manufacturer of the device.
2.3 Intended Use
2.3.1 Hardware
The device is intended exclusively for use as an LF power amplifier. Typical applications are the
operation as voltage amplifier on passive loads. Active loads are only permitted under certain
conditions in agreement with the manufacturer.
Operation on active loads
Active loads are only permitted under certain conditions in agreement with the manufacturer.
The device may only be operated within the technical data and under the ambient conditions
specified in this manual.
Changes to the device are not permitted without the consent and release of the manufacturer.
Proper and safe operation of the device requires correct installation and careful operation. This
manual is part of the device and must always be accessible to the user. Observe all safety
regulations listed in this manual.
The improper use leads to the exclusion of any liability claims.
The operator alone is liable for all damage caused by improper use.
A1230-01
For Your Safety
Page 6
