P/N KIL00921398 FORM NO. K1398 R01/13 ECO-6-010-13
Sheet 2 of 4
INSTALLATION INSTRUCTIONS:
FLOOD LIGHT WITH YOKE MOUNT
: (See
Figure 1
)
1. For convenience, install the yoke bracket on the trunnion
before mounting the structure.
2. Loosen bolts (
A
) - aim the floodlight to the desired spot.
3. Tighten both bolts (
A
) securely.
4. Fasten the yoke bracket to the mounting location using ½”
bolts/fasteners.
IMPORTANT NOTE:
Turn off electricity to circuit at main fuse or at circuit breaker.
1. Run supply wire to fixture through applicable hub (
B
) on back of fixture.
Make watertight joint using sealing fittings at threaded hub at the back of
fixture. The hub is threaded ¾”-14NPT.
2. Loosen and remove all but one of the access door captive screws (
C
).
Rotate access door (
D
) to allow for entry into fixture. See
Figure 2
for
more details.
3.
CAUTION
- Connection as described below requires the use of either
insulated wire nuts or, as an alternate, a factory installed terminal block
assembly. See below:
Connection Method (Insulated Terminal Block Assembly)
Standard Wiring Method
INSTALLATION INSTRUCTIONS (CONT.):
4. Replace access door (
D
) and access door captive screws (
C
).
Securely tighten screws (
C
). See
Figure 2
for more details.
5. Turn on electricity to verify fixture is operating properly.
Figure 2
B
D
KFL Series with Factory
Installed Terminal Block
L
L2/N
G
Blac
k
White
Green
Insulated Wire nut
C
SUPPLY
LUMINAIRE
L1 (IN)
G (IN)
L2/N (IN)
Black
White
Green
Terminal Block
L1 (IN)
G (IN)
L2/N (IN)
Black
White
Green
L1 (OUT)
L2/N (OUT)
G (OUT)
Terminal Block
LUMINAIRE
SUPPLY
Connection Method (Insulated Terminal Block Assembly)
Loop In / Loop Out Wiring Method
SUPPLY
LUMINAIRE
Standard Connection Method (Insulated Wire Nuts)
