P
AGE
5 of 19
S.M.A.R.T. ADA-C
OMPLIANT
E
MERGENCY
P
HONES
42004-351H
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-351h.doc
02/05
Model 293-003, 293AL-003, and 294AL-003
The mounting and wiring instructions for Models 293-003, 293AL-003 and 294AL-003 are as follows:
1.
Remove the front panel of the telephone by
removing the 4 tamper-resistant screws.
2.
Remove the front panel of the enclosure.
Carefully place the front panel assembly in a safe
location while installing the back box.
3.
Position the enclosure on the mounting surface.
The enclosure provides four 0.28-inch mounting
holes. Secure it with the four ¼-inch diameter
bolts of the appropriate length for the mounting
surface.
4.
Prepare the enclosure for cable entry. For
example if conduit is installed, create an access
hole using a Greenlee-type punch that is
equivalent in size to the conduit diameter.
5.
When the telephone line has been pulled into the
phone enclosure, either connect the cable directly to TB1 (Tip and Ring terminals) or install a
modular jack in the back of the enclosure and connect the pre-installed modular plug to the jack.
6.
Using the Setup section of this manual,
•
Make hardware configuration changes.
•
Adjust the audio levels if necessary.
•
Perform the initial programming.
7.
Verify operation by calling to and from another
phone.
8.
Complete the installation by attaching the front
panel assembly to the rear enclosure using the 4
tamper-resistant screws.
N
OTE
:
When using the GAI-Tronics Model 231 Pole
Mounting Kit, follow the mounting instructions
provided in the kit.
Figure 1. Model 293-003 and Model 293Al-003
Figure 2. Model 294AL-003
