P
UB
.
42004-352K
ADA-C
OMPLIANT
E
MERGENCY
P
HONES
P
AGE
9
of 29
d:\standard ioms - current release\42004 instr. manuals\42004-352k.doc
06/06
Models 297-001 and 298-001
Figure 9. Model 297-001
Figure 10. Model 298-001
Stanchion or Flush-mount Applications
1.
When mounting in a GAI-Tronics Model 234 Series Stanchion, or for flush-mount installations, the
supplied back box must be used to mount the Model 297-001 or 298-001 Telephone. Mount the back
box to the structure using the appropriate hardware. Refer to Figure 11 cutout dimensions.
2.
If mounted outdoors, the installation of a telephone line suppressor (customer-supplied) on the
telephone line is recommended.
3.
Remove the tapered plug from the top or bottom cable entry hole in the back box, and install the
telephone line and cable fitting.
4.
Telephone line connections directly to TB1 are acceptable.
5.
If using the modular jack, remove the cover, and connect the red and green wires of the telephone line
to the red and green wires of the modular jack. Replace the modular jack cover.
6.
Connect the telephone’s modular plug to a USOC RJ11 or CA11A (Canada) modular connector or (if
applicable) the telephone line suppressor. Refer to Figure 8 for the Model 297-001 and 298-001
component locations.
7.
Perform the initial programming of the phone. Refer to the Programming section beginning on page
16.
8.
Make hardware configuration changes, if necessary. Refer to page 12. Verify operation by calling to
and from another phone.
9.
Adjust the speaker levels if necessary. Refer to the Audio Level Adjustments section on page 14.
10.
Attach the telephone’s front panel to the mounting flanges of the back box using the six supplied
#10-32 tamper-resistant screws and washers.
