Pub. 42004-338K
G A I - T R O N I C S
®
A H U B B E L L C O M P A N Y
Rugged Analog Auto-Dial Telephones
GAI-TRONICS 3030 KUTZTOWN RD. READING, PA 19605 USA
610-777-1374
◼
800-492-1212
◼
Fax: 610-796-5954
V
ISIT WWW
.
GAI
-
TRONICS
.
COM FOR PRODUCT LITERATURE AND MANUALS
Confidentiality Notice
This manual is provided solely as an installation, operation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third
party.
General Information
GAI-Tronics Rugged Auto-Dial Telephones are ideally suited for conditions that are too harsh for a
standard telephone. When the handset is removed from the cradle, a preprogrammed number of up to 31
digits is automatically dialed. The telephones are fully line-powered and do not require internal batteries.
This manual applies to the following telephones:
•
Model 227-001 Public Access Auto-dial Telephone
•
Model 247-001 Indoor Industrial Auto-dial Telephone
•
Model 257-001 Weatherproof Industrial Auto-dial Telephone
•
Model 277-001 Flush-Mount Auto-dial Telephone
•
Models 277-002BH and 277-002BHAC Flush-Mount Behavioral Health Telephone
Operation
To auto-dial the stored telephone number:
1.
Lift the handset. After approximately 1 second, the preprogrammed number is dialed automatically.
2.
The handset receiver volume is adjustable using the handset pressbar or the volume control
pushbutton located on the front of the telephone. The volume increases with each button press in six
steps. Pressing the volume control a seventh time will reset the volume to the original level. When
the handset is returned to its cradle, the receiver volume is returned to the initial volume setting. This
behavior can be changed by the volume control jumper setting (see the Volume Control Jumper
Setting section).
3.
To redial, place the handset on hook and wait approximately 3 seconds. Lift the handset and the
preprogrammed number is redialed.
4.
Place the handset back on-hook after completion of the call.