Page 3
Kim Lighting • 16555 E. Gale Ave. • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/330-3861
WARNING:
The H.I.D. / Fluorescent fixture utilizes a lamp that
may contain mercury. For information on disposal of
lamp go to website:
www.lamprecycle.org
Vandal Resistant Bollard
Installation Instructions
VRB1/VRB3 & VRB2/VRB4
3. Install lamp of type and wattage shown on fixture
label. Make sure globe gasket surface is clean.
Reinstall globe and retaining strap making certain
pressure pad is in place around retaining strap
before installing hex nuts.
4. Replace top cap by aligning screws with keyhole
slot openings. Turn top cap counterclockwise and
tighten screws.
BALLAST REPLACEMENT INSTRUCTIONS:
Make certain the electrical supply is
OFF
before starting replacement.
3. Place fixture over the ballast assembly and slowly turn until it drops into retaining slots; twist shaft clockwise 45° to
lock onto the base casting. Tighten the two set screws at the base of the fixture.
!
LAMP INSTALLATION OR REPLACEMENT INSTALLATION INSTRUCTIONS
cont'd.
1. Loosen two
J
-20 set screws located near bottom
of fixture using a
F
” hex key. Rotate the fixture
counterclock-wise approximately 1” and lift upward
to clear ballast assembly.
2. Replace ballast with the correct type and wattage.
Connect all wiring as shown in the wiring diagram
on the new ballast.
