B30-LED Series 8" Round Traditional Bollard
Installation Instructions
7/29/14 EC 140731001 Status A
Part No. 93054328
Tools Required:
q
Ratchet with 9/16" deep socket
q
3/16" Hex Key
q
1/8” Hex Key
q
9/16” Open End Wrench
q
Flat Blade Screwdriver
!
Base Casting Installation:
Make certain electrical supply is
OFF
before starting installation.
1.
Install the base casting on the pre-set anchor bolts. Use flat washers and hex
nuts both below and above the base casting.
2.
Level the top edge of the casting by adjusting the bottom leveling nuts.
Tighten the upper nuts.
3.
Connect the circuit ground wire to the grounding lug on the ballast bracket.
4.
Connect power supply leads to the driver input leads.
Fixture Installation:
Make certain electrical supply is
OFF
before starting installation.
1.
To protect finish, lay fixture horizontally on soft cloth with open end of
fixture next to installed base casting.
2.
Connect fixture ground lead (green) to the short green wire connected to
the grounding lug on the driver bracket.
3.
Connect the LED module leads to the driver.
4.
Place pole body over base casting and slowly turn until body drops into
retaining slots, then twist clockwise to lock the pole onto the base casting.
5.
Tighten the two set screws at the bottom of the pole using a 3/16" hex key.
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code. Failure to do
so may result in serious personal injury.
CAUTION: All wiring must be done by a qualified electrician.
KEEP THIS SHEET FOR FUTURE REFERENCE.
!
16555 East Gale Avenue
City of Industry, CA 91745-1788
626/968-5666 • FAX 626/968-5716
B30-LED
Top Cover/
Lens Assembly
Reflector
Assembly
Base
Assembly
Riser
(Pole Body)
Base Casting
Conduit
(by others)
Anchor Bolt (4)
Concrete
Concrete Pad
Leveling Nut
and Washer (4)
Nut and
Washer (4)
Riser/
Pole Body
Base Casting
Assembly
Earth, Grade
Slopes Away
Final Installation Detail
!
Level
3" Max.
Grade
Base Casting Assembly
Fixture Installation
