A. SD Card Installation/ 安装 SD 卡
Device Installation/ 设备安装
2
Align the screw holes on the wall mount with the screw holes on the pole mount, and use the M8 screws to
secure the bracket.
将壁装支架上的螺孔与抱装支架上相应的螺孔对齐，拧紧 M8 螺钉。
B. （Optional）Install the optical module/（可选）安装光模块
C. Pole-Mounted Installation/ 立杆抱装
Use a All wrench to remove the shield, install the SD card.
使用内六角扳手将球机护罩卸下，插入 SD 卡。
Do not attempt to remove the PTZ dome camera yourself. Do not remove the protective film from lens before
installation is complete.The related pole, ceiling, wall and brackets must be capable of bearing more than 15 Kg
weight. The installation must be stable and solid. Also, nearby magnetic field interference needs to be avoided.
禁止私自拆解球机，安装完成前切勿撕下镜头保护膜。安装此设备的立杆、天花板、墙壁和支架，需确保在承重15Kg时稳定
性较好，并确保各安装环境的牢固、可靠。同时，应避免球机附近存在磁场干扰。
CAUTION/ 注意
Use a hex key to loosen cover screws, hold down the fastener buttons on the side of the camera, and open the
cover. Insert an SFP optical module into the SFP interface and connect an optical fiber (LC) properly to the SFP
optical module.
用内六角扳手拧开顶盖螺丝，按下摄像机侧面的 2 个卡扣按钮，打开顶盖。将 SFP 光模块插入顶盖的 SFP 接口，并将光纤（LC
口）按收发标识插入 SFP 光模块对应的接口中。
C. Pole-Mounted Installation/ 立杆抱装
1
3
Open up the three hose clamps and thread them through the installation holes on the pole mount. Thread the
cables that need to connect to the pigtail cables of the PTZ dome camera through the pole mount and wall
mount. Then use the hose clamps to affix the pole mount to the pole.
将 3 个喉箍拧开，穿过抱装支架的安装孔。将需要与球机尾线对接的线缆穿过抱装支架和壁装支架。将抱箍环绕在柱杆上，
拧紧抱箍，将抱装支架固定在柱杆上。
SFP_RX
SFP_TX
RX
TX
