Huawei SmartAX MA5600T, Руководство по настройке

Страница: 248 / 1979

MA5603T/MA5608T is deployed in floor 1, building 01 of community A. To add port
description according to the plan, do as follows:
huawei(config)# port desc 0/2/0 description A-01-01/0-2-0
huawei(config)# display port desc 0/2/0
------------------------------------------------------------
F/ S/ P IMA Group Port Description
------------------------------------------------------------
0/ 2/ 0 - A-01-01/0-2-0
------------------------------------------------------------
2.3 Configuring the Attributes of an Upstream Ethernet Port
This topic describes how to configure the attributes of a specified Ethernet port so that the system
communicates with the upstream device in the normal state.
Prerequisites
The board in the GIU slot must be in position and must work in the normal state.
Context
The MA5600T/MA5603T/MA5608T should be interconnected with the upstream device
through the Ethernet port. Therefore, pay attention to the consistency of port attributes.
Default Configuration
Table 2-1 lists the default settings of the attributes of an Ethernet port.
Table 2-1 Default settings of the attributes of an Ethernet port
Parame
ter Auto-
negotiation
mode of the
port Port rate Duplex
mode Network
cable
adaptation
mode Flow
control
Default
Setting
(Optical
Port) l
GICD/
GICF/
GICK:
enabled
l Other GIU
board:
disabled
l
FE optical
port: 100
Mbit/s
l GE
optical
port: 1000
Mbit/s
l 10GE
optical
port:
10000
Mbit/s
Full-duplex,
read only Not
supported Disabled
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
2 Basic Configurations
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
223