8
2.2
Getting Started
To power on the HG523, press the power button on the top of the HG523.
),
solid on. The POWER indicator is also solid on, which indicates that the HG523 is
After you power on the HG523, the ADSL indicator blinks (for less than three minutes
which indicates that the HG523 is being activated. Later, the ADSL indicator turns
working properly.
3
Setting the Network-Access Parameters
B
y configuring the HG523 and your computer, you can choose any of the following
methods to surf the Internet:
z
Accessing the Network Through the Embedded PPP Dial-Up Software on the
HG523
z
Accessing the Network Through the PPP Dial-Up Software on Your Computer
3.1
Accessing the Network Through the
Embedded PPP Dial-Up Software on the HG523
set up a dial-up
connection au
on your c
p
computer
your com
68.1.1
ter
.
By defau
admin
. After the user name and
the passw
uration utility.
Step 2
tility,
he
5.
If you select this method for accessing the network, the HG523 starts to
tomatically after the startup. You can access the network after you power
om uter. You do not need to install any special dial-up software on your
or perform dial-up operations on your computer. To configure the HG523 and
puter for the network access, do as follows:
Step 1
Log in to the Web-based configuration utility of the HG523.
1.
Launch the Internet Explorer on your computer. Enter
http://192.1
in the address bar, and then press
En
2.
In the displayed dialog box, enter the user name and the password, and
then click
OK
.
ame and the password are
lt, both the user n
ord are verified, you can access the Web-based config
Enable the embedded dial-up function.
1.
In the navigation tree on the left of the Web-based configuration u
choose
Basic
>
WAN
.
2.
Click
New
.
onnection
.
3.
Select
Enable
check box for
WAN c
4.
Enter the VPI and VCI that are provided by the network operator in t
VPI/VCI
text boxes.
Select
INTERNET
from the
Service list
drop-down combo box.
