Port
Type
Quantity
Description
PSU socket
-
2
Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the
quantity of PSUs, ensure that
the rated power of the PSUs
is greater than that of the
server.
● If only one PSU is used,
Predicted PSU Status cannot
be set to Active/Standby on
the iBMC WebUI.
Table 5-5 LOM port description
Chip Model
Port Type
Rate
Negotiation
Mode
Supported
Rate
Rates Not
Supported
X722
10GE optical
port
Auto-
negotiation
10000 Mbit/s
(full duplex)
10000M
10/100/1000
M
GE electrical
port
Auto-
negotiation
1000 Mbit/s
(full duplex)
1000M
10/100M
● Use
Intelligent Computing Compatibility Checker
to obtain information
about the cables and optical modules supported by the LOM ports.
● The LOM ports support NC-SI and PXE.
● The LOM ports do not support forced rates.
● The electrical LOM ports cannot be connected to power over Ethernet (PoE)
devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE
device may cause link communication failure or even damage the NIC.
● The electrical LOM ports do not support SR-IOV.
● Forcibly powering off a server will cause intermittent NC-SI disconnection
and disable the Wake on LAN (WOL) function of the LOM ports. To restore
the NC-SI connection, refresh the iBMC WebUI.
Huawei FusionServer Pro 2488H V5 Server
Technical White Paper
5 Hardware Description
Issue 03 (2020-04-20)
Copyright © Huawei Technologies Co., Ltd.
21
