eSpace IAD208E(M) Integrated Access Device
Quick Start
5
FAQs
Issue 04 (2012-06-11)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31
6.
Q: How do I view the IP address of the IAD?
A: Connect a phone to the IAD, and dials *127. The IAD automatically plays an
announcement indicating the IP address. For details, see the product document.
7.
Q: How do I change the IP address of the IAD?
A: For details, see
Maintenance
>
Changing IP address
in the product document.
8.
Q: How do I view the MAC address of the IAD?
A: You can view the MAC address in either of the following ways:
−
Log in to the web management system, and choose
Basic Configuration
>
Network Parameter
.
−
Log in to the CLI, and run the
enable
and
configure terminal
commands in
sequence to enter the global configuration mode. Then run the
display
mac-address
command.
9.
Q: How do I view the physical sequence number of the IAD?
A: Log in to the CLI, and run the
enable
and
configure terminal
commands in
sequence to enter the global configuration mode. Then run the
display
physical-serial-num
command.
10.
Q: How do I view the elabel of the IAD?
A: Log in to the CLI, and run the
enable
and
configure terminal
commands in
sequence to enter the global configuration mode. Then run the
display elabel
command.
11.
Q: How do I set the upper and lower limits of the hookflash duration?
A: Log in to the CLI, and run the
enable
and
configure terminal
commands in
sequence to enter the global configuration mode. Then run the
dev parameter set 3
command to set the upper limit, and run the
dev parameter set 4
command to set
the lower limit.
12.
Q: How do I view the software version of the IAD?
A: You can view the software version in either of the following ways:
−
Log in to the web management system, and choose
Basic Configuration
>
Version Information
.
−
Log in to the CLI, and run the
enable
and
configure terminal
commands in
sequence to enter the global configuration mode. Then run the
display version
command.
13.
Q: How do I change the protocol?
−
A: To change to the SIP mode, log in to the web management system, choose
Advanced Configuration
>
Protocol Mode
, and select
SIP
; or log in to the
CLI, run the
enable
and
configure terminal
commands in sequence to enter the
global configuration mode, and run the
protocol-mode sip
command.
−
To change to the MGCP mode, log in to the web management system, choose
Advanced Configuration
>
Protocol Mode
, and select
MGCP
; or log in to
the CLI, run the
enable
and
configure terminal
commands in sequence to enter
the global configuration mode, and run the
protocol-mode mgcp
command.
14.
Q: How do I view the system information?
