eSpace 6805 IP Phone
Administrator Guide
6 Appendix
Issue 01 (2014-01-06)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
117
Figure 6-39
Complete the DHCP server
After the setting is complete, if some IP phones are set to obtain IP addresses through DHCP,
the DHCP server allocates the IP addresses in the IP address pool to the IP phones one by one.
If the lease of IP addresses is not renewed, the DHCP server withdraws the IP addresses for
use of other devices.
----End
6.6.2 Setting Up the DHCP Server on Router AR-28
The configuration scripts and remarks for logging in to router AR-28 and enabling the DHCP
server function are as follows:
<Quidway>system-view //Enter the configuration mode.
[Quidway]dhcp enable //Enable the DHCP server function of the
router.
[Quidway]dhcp server detect //Verify the DHCP server function.
[Quidway]interface Ethernet 0/1 //Connect to network port 1 on board 0.
You must make sure that the network cable is inserted into network port 1 of board 0 on router AR-28.
In the rear panel of the router, you can view the board slots and enable DHCP function on network port
1.
[Quidway-Ethernet0/1]ip address 192.168.2.1 255.255.255.0 //Set the IP
address of network port 0/1. The router also uses the IP address as the gateway
address and allocates the IP address to the DHCP client.
