Device Installation/ 设备安装
B. Wall-mounted Installation/ 壁装
3
2
Use the screws to fix the wall mount to the wall.
使用螺钉将壁装支架固定到墙壁上。
Unfasten the screw marked with
a
on the universal joint for the universal joint to rotate freely. Fasten screws
marked with
b
and
c
to fix the camera to the universal joint. Fasten all screws on the universal joint.
拧松万向节上 a 处的螺钉，使得万向节可以自由转动。拧紧 b 和 c 两处的螺钉，将摄像机固定到万向节上。拧紧万向
节上的所有螺钉。
3
Place the mount in the desired installation position. Use a marker to mark the screw locations. Use an 8
mm drill bit to drill the holes to a depth of about 55 mm. Use a hammer to carefully drive the white plastic
expansion tubes into the holes.
将支架放置于安装位置 , 使用记号笔绘制螺钉安装位置，选择直径为 8mm 的钻头，钻取深约 55mm 的导孔。 使用
羊角锤将白色膨胀管打入钻好的孔内。
1
b
a
c
1
2
Unfasten the screw marked with
a
on the universal joint for the universal joint to rotate freely. Fasten screws
marked with
b
and
c
to fix the camera to the universal joint. Adjust the vertical monitoring angle, and fasten
all screws on the universal joint.
拧松万向节上 a 处的螺钉，使得万向节可以自由转动。拧紧 b 和 c 两处的螺钉，将摄像机固定到万向节上。调整好垂
直监控角度，拧紧万向节上的所有螺钉。
3
Thread the hose clamps through the installation holes on the pole mount. Place the hose clamps around the
beam and tighten them up.
将喉箍环穿过抱装支架的安装孔，并环绕在横臂上，拧紧喉箍。
b
a
c
Loosen the hose clamps and remove them. Install the universal joint in the #2 holes on the pole mount (for
the #2 hole identifier, see the silk screen on the physical device).
将喉箍拧开，卸下支架上的喉箍环。将万向节安装到抱装支架 2 号孔位（2 号孔位标识请参见实物上的丝印）。
C. Beam-Mounted Installation/ 横臂抱装
