INSTRUCTIONS FOR SOFTWARE OPERATION
---------P8--------
2.3 Setup the attributes of the thermometer data logger
To setup the attributes of the thermometer data logger according to different requirements before the
normal working, click the
button on the toolbar, or select Setup from the menu.
z
: Get current setup information from the thermometer data logger. Click this button, and then the
old setup information is shown below.
z
: Synchronize the new setup information to the logger. After changing the configuration,
do not
forget
clicking this button to make sure that the new configuration is wrote to the logger.
The PC time
will be synchronized to the logger as well.
z
Name: Gives a name to the logger.
z
SN: Every logger has a SN with 10 characters. The length must be 10.
z
Sampling Interval: The interval of sampling.
z
LOG Intervals(s): The interval of recording.
z
Logs Count: The count of the logs that the logger has recorded.
z
MANU Count: The records in the memory. The maximum capacity is 88 readings. It will be recorded
when manually press the “MEM” button.
z
Capacity: The total capacity of the logger storage. One reading includes time and three channels’
data.
z
Calibrate the logger:
The logger is factory calibrated to an accuracy given in the device
specifications. However, there may be times when you wish to adjust the calibration of your logger.
Tespro provides you with the ability to perform a single point offset calibration. This calibration can be
used to increase the accuracy of the logger for a restricted data range.
