10
Don’t pack the goods that may be damaged when vacuuming or after vacuuming with
this machine.
If you have any question about the operation and the function that haven’t stated in this
manual, please contact the manufacturer or distributor
If the machine is running irregularly or makes strange noise, please turn off the power
immediately to stop the running and finally cut off the power.
Once there is any problem, please contact the manufacturer or distributor
Vacuum chamber lid
Don’t place the machine nearby heat source to avoid the damage of vacuum lid.
Don’t put the stuff of heat, sharp or heavy on the top of vacuum lid, or may lead to the
damage of vacuum lid.
Please use solvent-free detergent to clean the vacuum lid. Solvent can damage the
vacuum lid.
Please check whether the vacuum lid cracks at least once a week. If find the
vacuum lid has crack, the machine should not be used until the old vacuum lid
is replaced by a new one., or there may occur inner-explosion of vacuum lid. The
manufacturer is irresponsible for accident or damage caused by using vacuum lid
with cracks.
As measure of prevention, the vacuum lid should be replaced every three years
referring to the standard maintenance cycle.
Vacuum pump
Make sure the vacuum pump is filled with appropriate special oil before using.
Please check the oil level & quality at least once a week. If oil level is too little or oil
emulsify or deteriorate, the vacuum pump oil should be replaced.
Only the special oil for vacuum pump can be used for the machine. Refer to the
“Maintenance” chapter.
1. Power on
Start the machine by turning the Power Switch, which is placed in the left side of the
machine.
Turn the Power switch to the Position 1, the machine monitor shows “
□ □
”, which
Power
Содержание HVC-260T/1A
Страница 35: ...34 J Electric Circuit Diagram...
Страница 36: ...35 K Gas Circuit Diagram...