lp-586 Rev. 000 Rel. 001 Date 2.12.18
13
C. Remote Control (Optional) Description
Figure 21 - Remote Control Detail
Power Button
Pressing this button turns the fan coil on and off.
Mode Button
Press this button to choose from the Automatic, Cooling, Dehumidifying, Ventilating, and Heating Modes.
Fan Speed Button
Press this key to choose from High, Medium, and Low Fan Speeds.
Up Arrow
Increase the setting by pressing this button.
Down Arrow
Decrease the setting by pressing this button.
Table 4 - Display and Control Descriptions
NOTE:
Take out the batteries from the remote if it is not to be used
for a long time. If the remote is not working properly, take out the
batteries for thirty-five (35) minutes to allow it to reset. Replace the
batteries. The remote should work normally.
D. Using the Remote Control
1. F. Cool and F. Heat Function
Press the “F. Cool” or “F. Heat” buttons to automatically set the fan coil
to either Cooling or Heating Mode at high fan speed.
2. Time Setting
Press and hold the button until the time value flashes. Adjust the
current time value by pressing
to increase or
to decrease.
To save the time setting, press the button again.
NOTE:
A 12 hour clock displays the current time value. A 24 hour clock
is not available.
3. Timing Start-Up or Timing Shut-Down
NOTE:
Timing Start-Up is only available when the fan coil IS NOT
operating. DO NOT shut power supply off to the fan coil when setting
Timing Start-Up. Timing Shut-Down is only available when the fan coil
IS operating.
Press the Timing Start-Up
button while the fan coil is not
operating to set Timing Start-Up. Use the
or
buttons to set the
number of hours the fan coil will operate. The unit will automatically
begin to operate one hour after setting Timing Start-Up.
NOTE:
The range of Timing Start-Up is from 1 to 11 hours. If the setting
is over 11 hours the Timing Start-Up setting will be cancelled.
