HTL DS Series, Руководство по эксплуатации

Страница: 12 / 32

OUTSIDE UK: +44 (0) 1670 700 018
11
Setting Torque
Once the system is fully connected and proper power supply available, it is time to adjust the pump
pressure to the level needed on your job.
When tightening, use the manufacturer’s specifications to determine the torque value which you will
ultimately require.
Torque sequence may vary from plant to plant and even within individual plants, depending upon the
gasket material, etc. Always abide by local procedures.
Next, use the pressure-torque conversion chart that is provided for the individual tool, similar to the one
below.
An example of finding the torque required is as follows:
Assume you are going to use a HTL-W2 tool to torque a 1 ¼ bolt to 835 ft.lbs.
1. First check the serial no. on the tool corresponds to the torque chart. On the left hand side of the
chart is the torque values. Find 835 ft.lbs on column
2. Then move across the chart until you come to a diagonal line.
3. At this point, move down to the bottom of the chart. The corresponding pressure value can be
found
4. For example the pressure is 5,300 psi on a tool to produce 835 ft.lbs.
5. Now set pressure on pump as follows in next section.
10,000 PSI = 1633 FT. LBS
1800
1700
1600
1500
1400
1300
1200
1100
1000
900
800
700
600
500
400
300
200
100
1000 PSI= 1171FT.LBS
0 1000 2000 3000 4000 5000 6000 7000 8000 9000 10000 11000
IN PUT (PSI)
Calibration Readout
Tor
que V
alues FT/Lbs
HTL-Operating-Instructions-DS.indd 12 11/04/2017 10:15