Hsun HS700UTV, Руководство по обслуживанию

Страница: 43 / 150

GENERAL INFORMATION
1-31
Seal Replacement
Seals ( Figure 47 ) contain oil, water, grease or combustion gasses in a housing or shaft.
Improperly removing a seal can damage the housing or shaft. Improperly installing the seal can
damage the seat. Note the following:
1. Prying is generally the easiest and most effective
method of removing a seal from the housing.
However. Always place a rag underneath the pry
tool to prevent damage to the housing. Note the
seal’s installed depth or if it is installed flush.
2. Pack waterproof grease in the seal lips before the
seal is installed.
3. In most cases, install seals with the
manufacturer’s numbers or marks facing out.
4. Install seals with a socket or driver placed on the
outside of the seal as shown in. Drive the seal squarely into the housing until it is to the correct
depth or flush as noted during removal. Never install a seal by hitting against the top of it with a
hammer.
STORAGE
Several months of non-use can cause a general deterioration of the motorcycle, UTV This is
especially true in areas of extreme temperature variations. This deterioration can be minimized with
careful preparation for storage. A properly stored motorcycle is much easier to return to service.
Storage Area Selection
When selecting a storage area, consider the following:
1. The storage area must be dry. A heated area is best, but not necessary. It should be insulated to
minimize extreme temperature variations.
2. If the building has large window areas, mask them to keep sunlight off the UTV .
3. Avoid buildings in industrial areas where corrosive emissions may be present. Avoid areas close to
saltwater.
4. Consider the area’s risk of fire, theft or vandalism. Check with an insurer regarding UTV coverage
while in storage.
Preparing the Motorcycle for Storage
The amount of preparation a motorcycle should undergo before storage depends on the expected
length of non-use, storage area conditions and personal preference. Consider the following list the
minimum requirement:
1. Wash the UTV thoroughly. Make sure all dirt, mud and other debris are removed.