HSP MX40P, Инструкция по монтажу

Страница: 6 / 16

Using a
2 mm
diameter drill bit set to
5 mm
drill stop. Drill two pilot holes. Attach small gas strut bracket using self
drilling screws provided. Repeat process on other side of tray.
Refer to Fig. 2 and Fig.3
Important:
DO NOT over tighten screws. Recommended tightening torque is 1- 3 Nm
Clean header rail (where extrusion will sit) with alcohol wipes provided and wipe away residue with a dry clean cloth.
Place the extrusion tape seal along the top of the header rail with the sealing lip facing towards the tailgate. Start the
extrusion at the edge of the side rail. IMPORTANT: Position extrusion as close to the header rail rear radius. Rub
down firmly to ensure maximum adhesion.
Gas Struts:
Measure from the front rail inside of tub, measure along top edge of tray 900 mm (windscreen end)
then down
20mm
and mark the screws position for the gas strut bracket. Position the gas strut
bracket accordingly, mark two mounting holes and centre.
Refer to Fig. 1 and Fig. 2
900 mm
Fig.1 - Gas strut bracket location
20 mm
Fig.2 - Gas strut bracket location
Fig.3 - Gas strut bracket fitment
Attach small shaft end of gas strut onto gas strut brackets, by clicking them in place.
Refer to Fig.4 with regard to gas strut orientation.
Fig.4 - Gas strut orientation
19
S700-220
1040
MX40P Page 6 of 16