HSP C25P, Инструкция по монтажу

Страница: 7 / 16

Important:
DO NOT over tighten screws. Recommended tightening torque is 1- 3 Nm
Clean header rail (where extrusion will sit) with alcohol wipes provided and wipe away residue with a dry clean cloth.
Place the extrusion tape seal along the top of the header rail with the sealing lip facing towards the tailgate. Start the
extrusion where the infill ends and run behind the hinges. IMPORTANT: Position extrusion as close to the header rail
rear radius. Rub down firmly to ensure maximum adhesion.
Turn the Sportsbar upside down. Remove front brackets from
sports bar only. Use 3 washer spacers inbetween bracket and
sports bar, make sure bracket is pushed out to the outside face
of the bars. Now tighten all bolts, this process is completed easi-
er if done one leg of sports bar at a time.
Front
Rear
Silicon needs to be applied to the underside of the moulded feet
cups to minimize the chance of water leakage.
C25P Page 7 of 16
22
22