
15
English
DIAGRAM OF PRE-ASSEMBLED PARTS
Once you open your Vario Gym® box you will see your product pre-assembled as shown in the illustration
below.
ASSEMBLING INSTRUCTIONS
LOWER PART ASSEMBLY
1. Remove the bolts from the support tubes (2 and 2A) and insert the steel bar. Fix them with the same
bolts previously removed.
1. Frame
2. Rear support tube
2A. Tube with a loop for the stretching rubber
bands
3. Base bars already attached to the support
tubes (2 and 2A)
4. Swing tubes
5. Backpedals
6. Handlebar and roller strip holding tube
7. Wing nut
8. Roller strip and stretching rubber bands
9. Handlebar height adjustment tube
10. Frame knob
11. Handlebar knob
12. Non-slip rubbers assembled to the base bars
13. Non-slip pedals
14. Handlebar
15. Steel bar
NOTE: The images and diagrams in this manual are for reference only. The actual appearance and
technical parameters are subject to change without previous notice.
2. Insert the frame (1) into the rear support end (2).mepeat the procedure with the opposite end and ad-
just it with the bolts (12) and lock washers (18) use both, the open end wrench and the Allen wrench.
Note: Make sure the loop
for the stretching rubber
bands is facing outwards.
Содержание VARIO GYM
Страница 2: ......
Страница 39: ...39 ...
Страница 40: ...HSP Hanse Shopping GmbH Im Hegen 1 22113 Oststeinbek Tel 040 22869407 ...