14
SECURIO B 34
12/2014
english
Other function modes
• Permanent mode
Application: Destroying large quantities of
paper
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down
and the shredder switches to standby.
Start: Press the operation button for three
seconds.
Premature cancellation: Press the
operation button.
•
Stand-by mode
Function: Two minutes after the last pa-
per feed operation, all consumers that are
not required are switched off automati-
cally.
The „Ready for operation“ indicator fl ash-
es briefl y at regular intervals.
The shredder starts automatically when
paper is fed in.
6 Troubleshooting
Display
Problem
Measure
Continu-
ous lamp
Paper
jam
You have fed in too much paper.
The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button “R” to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Overload
• The motor was overloaded. Let the shredder cool down for approx.
15 – 20 mins. before using it again.
Flashing
light
general
fault indi-
cator
• During paper destruction an error has occurred.
Pull the paper from the slot, so that the light barrier is free.
Shredded
material
container
full
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus.
Door
open
• Close the front door.
Click Here --->
For More Info