HSM Primo 3901, Руководство по эксплуатации

Страница: 12 / 72

12
Primo 3901 12/2011
english
6 Operation
Switching the paper shredder on
• Press rocker switch .
Rocker switch locks in place.
Green LED lights.
Paper shredder is ready for op-
eration (standby).
Feed paper
• Insert the paper to be de-
stroyed. See “Technical data”
for sheet capacity.
Automatic start stop control
starts the cutting system auto-
matically.
Paper is pulled into cutting
system and shredded.
When the paper fee ding opening is free
again, the cut ting sy stem au to ma tical ly swit-
ches off af ter app rox. 3 sec. and returns to
standby.
S
7 Troubleshooting
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Shredded material container full
Red LED lights.
Paper shredder switches off.
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
• Switch equipment off. To do this
tap rocker switch .
• Remove full shredded material
bag and insert new bag.
T
Door open
Red LED lights.
Paper shredder switches off.
• Check whether front door is
closed properly.
Paper jam
You have fed in too much paper.
Red LED lights.
The cutting device runs in re-
verse for approx. 2 seconds
automatically.
Pa per is pus hed out.
Notice Do not press rocker switch alter-
nately forwards/backwards ( - ). Cutting
unit could be damaged.
• Pull out the paper from the paper
feed opening.
If the paper is too low and cannot
be taken out: Activate the rocker
switch
several times brie fl y .
Light barrier must be free of ob-
stacles.
• Acknowledge the fault by switch-
ing the machine off and on again.
• Se pa ra te pa per stack.
• Press rocker switch .
• Feed in pa per successively.
T
S
Swit ching paper shredder off
• Tap rocker switch .
Switch returns to ze ro po si ti on.
T
Shredding CDs and disks (see “Prop-
er Use”)
Fold the safety element
down and feed the ma-
terial through the inser-
tion slot of the safety
element. This protects
you from splinters.