HSK HSK10 D, Руководство пользователя

Страница: 28 / 41

Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK10 DE

HSK Kunststoff Schweißtechnik GmbH
28
5.2 Setting of set-point temperature
The regulator is pre-adjusted at a set-point temperature of 220°C (mass temperature). This must be adapted by
the operator to the material to be welded.
For the setting of the set-point temperature please proceed as follows:
The desired set-point temperature is shown in Display No. 2 (pos. 3) of the regulator.
By actuating the “up-key” the set-point temperature is raised.
By actuating the “down key” the set-point temperature is reduced.
Never press the “display” and the “level” key at the same time.
By doing this, you will enter into a level of the regulator which can solely be modified by the
servicing personnel.
By re-
actuating the „display“and the „level“key you can return to the start position of the
regulator
5.3 Setting of air temperature
The air temperature can only be adjusted with the air heater itself.
For information please refer to the air heaters instruction manual.
6. Welding
After set mass and air temperatures are reached the welding process can be started.
The temperatures to be applied will depend on the material to be welded and can be taken from the
directions of the material’s supplier.
The following standard processing temperatures have been taken out of the DVS directions 2207, part
4:
Material Mass temperature (°C) Air temperature (°C) Air quantity (l/min)
HD-PE 200
– 230
250
– 300

300
PP 200
– 230
250
– 300 
300
7. Cutting off of manual welding extruder
After completion of the welding procedure, always empty the extruder by keeping it
running without welding wire until there is no more material coming out of the die.
Thereafter you cut off the air heating with the switch (item no. 21). As soon as the air
temperature is less than 100°C the air supply can be cut off.
After this the extruder can be cut off by pulling out the mains plug.
Attention:
If the air supply is cut off at the same time than the extruder or even before, the heater
cartridge may be damaged.