Step 5
.
By hand screw the struts onto the threaded studs as shown in Photo 6. If
you have a stand with different size struts keep in mind that you are building the
stand upside down. The struts you are installing now are the struts that will
become the struts between the top and second shelf when the stand is completed.
Note: Shelf spacing is approximately 3” less than the strut length. Verify you
have the correct strut length required for your system. HRS offers a variety of
strut lengths so consult your dealer if you are not certain you have the correct
parts for your desired spacing.
Step 6.
Screwing the struts (of same length) onto the threaded studs will begin
to get more difficult when they come in contact with the polymer rings. Use the
HRS Grip Pad (Photo 7) to torque all of the SXR Struts for this layer. Wrap the
HRS Grip Pad on the SXR Strut as shown in Photo 8. Using your hand on the
HRS Grip Pad to fully torque each strut as shown in Photo 9.. The strut has
proper torque when it is approximately
!
to
"
turn (approx 90 degrees or more)
after the strut is finger (snug) tight. For example Photo 9 below shows a strut
being tightened by rotating the strut clockwise using the HRS Grip Pad.
Note: it is important to get proper torque on struts to achieve proper frame
stiffness and performance.
Photo 6
