Second Panel Assembly
- Remove the second panel from the wooden crate and
place it in a separate area to remove all the packing material (see Photo 12 &
13). As noted before, the area and surface used should not pose any threat to the
integrity of the panel surface finish. Please follow the same procedure as noted
for un-wrapping the first panel.
Note: If assembling an MXR frame that consist of more than two panels then
install center panel (isolation base brackets on both sides) at this time as the
second panel
Photo 12 Photo 13
Remove all the foam and packing paper from the second panel. It is important
that two people perform the next step. With one person on each end of the panel,
very carefully and slowly place the attachment block of the second panel into the
top of the brace assembly until it contacts the step on the brace (see Photo 15).
Immediately install at least one 1/4-20 x 3/4" screw into each end on the panel
block and fully engage, but do not tighten the screws (see Photo 16).
Photo 14 Photo 15
