HRS AP109A, Инструкция по эксплуатации, Страница: 28 / 48

− 17 −
⑨ Deformed contact (Rolling)
Can be caused by the wear of the tool, positioning of the contacts in the crimping sections of the tool or handling of
the contact.
Excessive deformation of the contact will prevent insertion in the corresponding insulator (housing).
⑩ Deformed insulation barrel (Kickback)
Caused by the use of incorrect wire or contact.
Excessive protrusion may expose part of the contact after insertion in the corresponding insulator (housing) and
may cause electrical shorts.
⑪
Uneven anvil indentation
Caused by the wear of the anvil side of the tool.
Can cause degradation of the electrical connection.
⑫ Damage or nicks on the crimp’s outer surfaces.
Caused by damage or wear of the crimp sections of the tool.
Can cause deformation of the contact, cracks or peels of the material.
⑬ Too large or irregular crimping burr
Caused by damage or wear of the crimp sections of the tool.
Can cause deformation of the contact, cracks or peels of the material, degradation
of the electrical connection or loss of the wire retention.
⑧
Deformed contact (Twist)
Can be caused by the wear of the tool, positioning of the contacts in the crimping sections of the tool or handling of
the contact.
Excessive deformation of the contact will prevent insertion in the corresponding insulator (housing).
⑨
端子变形 ( 压接 )
有时由于工具的调节状态或齿轮模具磨耗、将工具安装于端子的状态以及端子的使用情况，而造成发生。如果压接
显著，则有可能造成无法插入到机箱。
⑩
绝缘筒的变形（回扣）
当使用了不符合工具的电线时发生。
如果回扣显著，当插入机箱之后，端子会从机箱露出，在耐压方面造成障碍。
⑪
芯线压接部分砧台痕迹的不均一
因砧台磨耗等而发生。
如果砧台痕迹不均一，电气性接触会变得不稳定。
⑫
压接面的损伤或撞痕
当夹紧器有损伤或磨耗时会发生。
如果压接面上有损伤或撞痕，有可能会发生端子变形或电镀剥等。
⑬
压接毛刺过大，左右不均一
当工具调节状态或钳紧不理想，或砧台存在磨耗、损伤时会导致发生。如果毛刺显著或明显左右不均一，有可能会
发生毛刺部分导致端子龟裂的情况，或发生电气性连接不稳定、强度不足、端子变形等情况。
⑧
端子变形 ( 捻线 )
有时由于工具的调节状态、将工具安装于端子的状态以及端子的使用情况，而造成发生。如果捻线显著，则有可能
造成无法插入到机箱。