General Information
6
light in the future.
We would provide light assembly and waterproof connector as a replacement kit.
Cut the old electric cord, strip each wire and re-connect them with our LED light
replacement by a 5C connector (PN1005). You could just replace the LED light
without replacing the whole electric cord which is in a good condition.
Figure 4.
Figure 3.
4. Using a rag to dry the water on the open side of the electric cord. Please follow the
wiring rules to connect the wires with the outlet of the M4-3A controller:
Brown to R
Half Yellow Half Green to G
Blue to B
Black to W
Grey to V+
Figure 4.
5. Roll remain electric cords around the LED light assembly, put it into the wet niche.
Screw on the face ring to secure the light assembly into the niche. Figure 4.
