Charging the Headset with the AC or USB adapter
Before using this device, please charge the
Headset’s module with the provided USB AC
adapter / charger. Please make sure that the
battery is fully recharged when you first time
use it. You may also use the USB cable and
charge the Headset via a USB port of a
computer. A normal charge will take about 4
hours.
The charging cable has a small USB plug for the Headset, and the large USB plug for the computer
or AC adapter / charger; please observe to correct orientation of the USB plug and socket before
inserting.
1)
Insert the USB plug of the charging cable, into the USB small jack of the Headset; you can
either charging by computer or AC adapter.
2)
While charging, the red LED on the Headset’s module will illuminate. When the charging is
finished, the red LED will turn off.
Tip:
To prolong the life of the built-in
Poly-Li battery, please charge the Headset
at least every
month. Also, avoid charging the Headset for more than 8 hours at a time.
Turning the Headset ON and Standby mode:
Press and hold the Power button on the Headset. After 3 sec you will hear a “BEEP” and the
blue LED will begin to flash. Let go of the Power button, and the unit will go in standby mode.
Turning OFF the Headset:
Press the Power button for 5 seconds or until you hear 2 “BEEP” tones and the light turns off.
To pair to your Bluetooth enabled mobile phone (or GPS device):
When the unit is off, press and hold the Power button. Keep holding the Power button until
you see a RED AND BLUE light flashing. It normally takes around 5-8 seconds (do not let go
when you see the blue light). You will also hear a “BEEP” tone when the unit enters pairing
mode. On your cell phone or GPS Bluetooth-enable device, search for T-COM, and attempt to
pair to the device, when the device is flashing red and blue. If requested, enter the pairing
code 0000, to set the phone to auto pairing mode.
